TS-9 MODS
I can modify any TS-9, original or reissue, to 100% TS-808 specs, using the original type JRC4558D IC chip. This will improve any TS-9 (especially the weak ones). I use an IC socket rather than simply soldering-in the IC chip. I do not normally use a socket on the TS9DX as there is not really enough room. I also modify the output section of the TS-9 circuitry to 808 specs, which couples directly to the input of your amplifier. I'll modify your TS-9 (original or reissue) for $45. (See below for pre-modified new TS-9s.) I also "blueprint" the circuit board and wiring while I'm in there. The workmanship on these is quite good, but there are often a few cold or weak solder joints that I can improve. On well used TS-9s there are often cracks in the circuit board or the power jack solder attachments which I can strengthen. I always beef-up the attachment of the AC adaptor jack with more solder. I also tighten up the pots and jacks which will cause problems if they move. For even more durability I have the KWS tour survival option to make it even stronger, for an additional $15 for those of you who tour heavily and don't want a pedal have any problems when you are away from home.
We can also install Red, Green, or Yellow LEDS along with our mods.
Switch Repairs
We can clean the switch on an original TS-9 for an extra $5. The reissues' switches do not come apart like the originals, I have had no luck trying to clean them. I have found a decent replacement switch, as older reissue switches are not holding up well. I will install a new switch for $10 during a modification. The Newest '98 and later switches seem to be holding up better, we do not replace them unless they are already flaky. See my FAQ for more info on cleaning an original 9 series switch.
